Lilburn, Georgia – September 26, 2018 – Honda (American Honda Motor Co.) is recalling over 1,350,000 vehicles due to the passenger frontal air bag inflator being at risk of exploding. The massive recall is part of a previously planned phased recall.
Later phases have been moved up due to the risk being determined to be more severe than previously thought with a higher risk, and more supply of the faulty part being available than had at first been thought. This recall includes three ranges of vehicles.
The first range of vehicles being includes certain 2014 Honda Insight and Acura TSX and TSX Wagon, 2014-2015 Honda Crosstour and Pilot vehicles nationwide, as well as certain 2014 Honda FCX Clarity and Fit EV vehicles in Florida, Hawaii, Puerto Rico, Texas, Alabama, Georgia, Louisiana, Mississippi, South Carolina, California, American Samoa, Guam, the Northern Mariana Islands (Saipan) and the U.S. Virgin Islands.
The second range of vehicles being recalled includes certain 2011-2013 Acura TSX, TSX Wagon and ZDX, Honda Crosstour, Insight, Fit and Pilot vehicles, 2011-2012 Honda Accord and 2011 Honda Civic NGV, Civic, Civic Hybrid and CR-V vehicles in Arizona, Arkansas, Delaware, the District of Columbia, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia and West Virginia.
The third range of vehicles being recalled includes certain 2010-2013 Acura TSX and ZDX, Honda Crosstour, Fit, Insight and Pilot, 2011-2013 TSX Wagon, 2010-2012 Honda Accord and 2010-2011 Honda Civic NGV, Civic, Civic Hybrid and CR-V vehicles in Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin and Wyoming.
According to the NHTSA Safety Recall Report, all these vehicles are equipped with certain air bag air bag inflators assembled as part of the frontal air bag modules.
These modules are utilized as original equipment or replacement equipment (such as after a vehicle crash with airbag inflation, which necessitates replacement of the original air bags).
The specific defective modules may explode due to propellant degradation, which can occur after long-term exposure to higher absolute humidity, temperature, and temperature cycling.
In the case of an inflator rupture, the force of inflation may cause metal fragments to pass through the air bag and into the vehicle interior at high speed.
Contact with such high speed, flying pieces of metal, should the inflation occur and metal pieces be fragmented, may result in serious injury or death to vehicle driver and/or occupants.
Timeline of events
In consideration of a sufficient supply of final remedy inflators, Honda consulted with the NHTSA about advancing the recall launch of Priority Group 10 vehicles, identified in an earlier investigation and recall of which this recall is a part.
Honda determined that a defect related to motor vehicle safety exists and decided to conduct a safety recall ahead of the fourth phase of the Takata DIRs scheduled for late 2018.
The registered owners of all affected vehicles will be contacted by mail by Honda. Honda will request all owners asked to take their vehicles to a Honda or Acura automobile dealer.
The dealer will replace the passenger frontal airbag inflator with a new inflator, at no cost to the vehicle owner. The recall is expected to begin November 13, 2018.
Check your car’s recall status using MotorSafety’s free vehicle lookup tool.